When using X-Series radio: Issue a warning on "Transmission Sequence Error" instead of stopping simulation.
Fix intermittent X300 Reference Clock error by adding a retry mechanism.
Avoid X300 FPGA hang when no PPS signal is connected and using more than one X300s.
Let user specify PSR ramp with 4 digits precision (0,0001m resolution) from the GUI.
Fix intermittent X300 DAC error by adding a retry mechanism.
Add almanac time of applicability offset control for GPS NAV message in Settings->GPS->General.
Fix iono and tropo values in raw log file for Lower L-band. Affects only the log file. The values use in the simulation engine are correct.
Fix crash on startup when current Nvidia driver does not support CUDA 8.0.
Add multipath propagation and LoS obstruction.
Add message type id zero for L2C CNAV.
Add message modification/corruption for L2C CNAV.
Add Signal Level offset for M-Code and BeiDou.
Y-Code can now be enabled/disabled while the simulation is running.
Add Armed state which allow more flexibility to synchronize SDX. Some SDR may take longer to initialize. The Arm state will prepare all hardware so that when the Start command is received, there will be minimal delay. This greatly improves software synchronization performance. Hardware sync is always a better option when tight sync is required.
Is is possible to change many settings in the Armed state such as the power sliders before the simulation starts.
Automatically archive simulator.log file if application is terminated improperly.
Let user specify time offset when synchornizing with timing receiver.
Add Velocity and Acceleration to receiver log file (csv)
Add optional Winsock 1 support for C++ API
In SdxApi lib, add WINSOCK1 definition in Configuration Properties->C/C++->Preprocessor->Preprocessor Definitions
In your dll or executable, change ws2_32.lib to wsock32.lib dependency in Configuration Properties->Linker->Input->Additional Dependencies
Support External Reference Clock of 38.4MHz.
Support dual BladeRF operation with Master/Slave configuration. (BETA)
Updated to "bladeRF Release 2016.06":
Integrated FPGA image v0.6.0
Integrated libbladeRF v1.7.2
REQUIRED FX3 Firmware version 2.0.0
Add streaming buffer size in preferences (affects HIL latency).
Add real-time GPIO control for X300/310 SDR (BETA).
Remote API version 16
Add Server and Client API Version getters
Add optional "Fail if version mismatch" parameter for RemoteSimulator.connect()
SetStartTimeOffset: Allows to specify an offset when synchronizing SDX with a timing receiver.
Fix health bits in Page 25, subframe 4 and 5 in GPS Nav message.
Fix TOW value in L2C signal. In some circumpstances, the TOW could be offset by 12 seconds.
When using user defined antenna pattern or no pattern for lower L-Band, the power was 3 dB higher than it should have been.
AS bit in GPS nav message is now properly updated when Y-Code is enabled.
Stop API command will no longer return an error if it is sent when SDX is already stopped and if the command has no timestamp.
Improve almanac extrapolation.
If you need access to the clients' site to download the binaries for this release, please contact us.