Updated Dektec DTA-2115B library to version 2019-02. This version increases the maximum sampling rate to 85MSPS on the DTA-2115B.
Fixed GPS TGD values loading from SDX configuration file.
Fixed GLONASS RINEX logging: RINEX file was sometimes missing the first ephemeris block used by SDX.
Fixed GPS CA empty messages in decoded downlink file.
Added the possibility to set a different GIVEI grid for each SBAS service provider.
Added SDCM and GAGAN service providers for SBAS message 18 IGP mask.
Added the possibility to set the current configuration as the default configuration
for all future simulations. Note: If a previously saved output template is found, SDX will load the template
only if no default configuration exists. We recommend that you save these outputs
as a default configuration from now on.
Added possibility to log downlink files before and/or after signal encoding.
It is now possible to add up to 5 concurrent DTA-2115B outputs.
Increased central frequency precision in Interference outputs.
When Doppler shift value is too high: SDX will now report a warning message instead of stopping the simulation.
Remote API version 25:
Added Commands :
SetIntTxIgnorePropagationLoss: Set whether a dynamic transmitter should
ignore propagation loss or not.
SetIntTxIgnoreVehicleAntennaPattern: Set whether a dynamic transmitter
should ignore the vehicle's antenna pattern.
SetDefaultConfiguration : Set the current configuration as the default configuration.
ResetDefaultConfiguration : Reset the default configuration.
ImportNmeaTrack: Import NMEA track file.
New: can now take optional loadDefaultConfig flag. By default, the default configuration is not loaded.
[Set/Get]IonoGridGIVEI: can now take an optional service provider, if not given, will set for every service provider and return WAAS values.
[Set/Get]IonoGridGIVEIAll: can now take an optional service provider, if not given, will set for every service provider and return WAAS values.
[Import/Export]IonoGridGIVEI: can now take an optional service provider, if not given, will import for every service provider and export WAAS values.
EnableLogDownlink/IsLogDownlinkEnabled: can now have optional before/after encoding values. By default, the downlink is created after signal encoding.
[Set/Get]VehicleTrajectoryCircular: can now take an optional OriginAngle.
[Set/Get]IntTxCircular: can now take an optional OriginAngle.
Removed BladeRF Output Type. This device is not supported anymore by Skydel SDX.
If you need access to the clients' site to download the binaries for this release, please contact us.